7. This section view may be used to increase the clarity and readability of assembly drawings. Which below is it?
a. Assembly section
b. Half section
c. Revolved section d. Full section
8. How do you call an imaginary line which shows where an object is imagined cut to obtain a sectional view?
a Cutting plane line
b. Section line
c. Hidden line
d. Object line
9. It is a fine line used to show the part of the object being cut inclined at 45 degrees angle Each line must have at least
2mm distance from each other. What is it?
a. Section line
b. Hidden line
c. Center line
d. Removed section
10. Below are the principles of sectioning except for one, which one is it?
a. It shows the type of material to be used in an actual project
b. It shows more detailed illustration particularly on the internal parts of the object
c. It describes the shape of the internal parts.
d. It is the most common type of assembly drawing
pa help po pleas
Share
Answer:
7. A
8. C
9. D
10. C
Explanation:
Thats my answer, Not sure in number 10 but i think its right hope its help you❤️