3. What type of measuring tool that is made of tampered steel about 1/8-inch- thick and % inch wide and 6to 12 inches long? a. Pull-push rule c. Steel tape b. Steel rule d. Try square 4. What tool that has a wedge-shaped and used to shear, cut, and chip metal? a. Cold chisel c. Punches b. Hammer d. Scraper 5. Which of the following tools does not belong to measuring tools? a. Clamps c. Micrometer caliper b. Combination square d. d. Steel rule 6. What kind of hand tool that is designed to turn screws? a. Center punch c. Screwdriver b. Hammers d. Try square 7. What type of file that is used for enlarging holes? a. Flat file c. Round file b. Mill file d. Square file
pasagot po please please thank you
Share
Answer:
3.B.steel rule
4.A.Cold chisel
5.A.Clamps
6.C.Screwdriver
7.D.Square file
Explanation:
Hope this answer helps