c. Write true if the statement is correct and false if otherwise:
1. A lat screw driver is used in driving at fastening positive slotted
SCTEN
2. Soldering Pencil is used to join two or more metal conductors
with the support of soldering lead melted around it.
3. Side Cutter Pliers is used for cutting or trimming of connecting wires
or terminal leads in the circuit board.
4. A multi-tester is used in boring holes in the plastics chassis.
5. A long nose pliers is used for holding, bending and sketching the
lead of electronics component or connecting wire.
6. Soldering is the joining of plastics using a filler material of a lower
melting point than that of the parent metalls to be joined
7. It only takes a second or two to make the perfect joint, which should
appear shiny.
8. A soldering iron must not be coated with a thin coat of solder.
9. Electrical termination of a signal involves providing a connector at
the end of a wire or cable to prevent an RF signal from being
reflected back from the end, causing interference.
10. Special training is required for soldering in printed circuit boards
and micro miniature component repair.
Share
1. True
2. True
3. True
4. True
5. True
6. True
7. False
8. False
9. True
10. True
----------------------------------------------
#CarryOnLearning
#BrainliestPlease
#HopeIHelped
#NewNormal2021