(i brainliest ko po yung mauna)
Arrange the following steps in making the network cable
_ Set the RJ45 connector (with the cable) on the pliers, and squeeze it tightly.
_ Make the other side of the cable (we called this side B-side) in the same way.
_After you made it, you don't need to care of the direction of the cable. (Any cable in this page is directionless --- that means you can set either end of the cable to the either device.)
_ Remove the outmost vinyl shield for 12mm at one end of the cable (we call this side A-side).
_ Arrange the metal wires in parallel (refer the each section's wire arrangement table). Don't remove the shield of each metal line.
_ Insert the metal wires into RJ45 connector on keeping the metal wire arrangement.
Share
The code for your answer is 34512