Let’s Try (Evaluation)
Directions: Write the correct answer on a separate sheet of
paper.
1. When measuring an engine cylinder, what precision tool is used?
a) divider
b) feeler gauge
c) inside caliper
d) outside caliper
2. Which of the following tappet clearance specification for intake valve;
a) 0.08-0.12mm
b) 0.18-0.22mm
c) 0.24-0.26mm
d) 0.28-0.32mm
3. What is the spark plug gap setting of an engine?
a) 0.028”-0.060”
b) 0.060”-0.070”
c) 0.070”-0.080”
d) 0.080”-0.090”
4. When using a plastigauge tool, the applied con rod bearing clearance strip must be?
a) 0.069-0.079mm b) 0.080-0.089mm
c) 0.090-0.101mm
d) 0.102-0.229mm
5.Which device is for delivering electric current from an8 ignition system
to the combustion chamber?
a) engine cylinder
b) piston
c) rocker arm
d) spark plug
Share
Answer:
1.c
2.b
3.a
4.a
5.d
Explanation:
basahin nyo po mabuti tama yan
Answer:
1.d
2b.
3.c
4.a
5.d
Explanation:
Yan po promise
pa branlies po plsss