procedure in testing continuity using multitetester?
Share
procedure in testing continuity using multitetester?
Sign Up to our social questions and Answers Engine to ask questions, answer people’s questions, and connect with other people.
Login to our social questions & Answers Engine to ask questions answer people’s questions & connect with other people.
Answer:
1.Turn the dial to Continuity Test mode. It will likely share a spot on the dial with one or more functions, usually resistance (Ω). With the test probes separated, the multimeter’s display may show OL and Ω.
2.If required, press the continuity button.
1.)First insert the black test lead into the COM jack.
2.)Then insert the red lead into the VΩ jack. When finished, remove the leads in reverse order: red first, then black.
3.)With the circuit de-energized, connect the test leads across the component being tested. The position of the test leads is arbitrary. Note that the component may need to be isolated from other components in the circuit.
4.)The digital multimeter (DMM) beeps if a complete path (continuity) is detected. If the circuit is open (the switch is in the OFF position), the DMM will not beep.
5.)When finished, turn the multimeter OFF to preserve battery life.
Explanation:
goodluck at godbless po